Crown K1 Power Amfi

İlan No
40346
Eklenme Tarihi
28.6.2019
Marka
Crown
Model
K1
Durum
3/5
Kargo
Kargo Maliyeti
0
Stok Sayısı
1
Fiyat
15000 TL 1.250 TL
Kullanıcı Bilgileri
Kullanıcı
Sencay Kopmazkaya
Puan
stars
Paylaş
Ürün Açıklaması

Crown K1 Power Amfi Çalışır durumdadır, sistemi dağıttığım için evde atıl durumda duruyordu, ihtiyacı olana yardımcı olmak babında fiyat cüzi tutulmuştur, Özellikle aktif sistemde kullanacak arkadaşlara şiddetle tavsiye ederim ben aktif sistemde bass amfisi olarak kullanmıştım 4000 Damping faktörüyle Hi-End ve inanılmaz bir performansı vardır. Specifications Power to spare, no matter what your configuration The Crown K1 Amplifier is rated to deliver 350 watts per channel at 8 Ohms, 550 watts into 4 Ohms or 750 watts per channel into 2 Ohms. In addition, in bridged mode the K1 has a capability of 1100 watts at 8 Ohms or 1500 watts at 4 Ohms - all while running without a fan! The K1 is cool, clean and quiet.  The following applies to 120-VAC, 60-Hz units in Stereo mode with 8-ohm loads and an input sensitivity of 26 dB gain unless otherwise specified. Specifications for units supplied outside the U.S.A. may vary slightly at different AC voltages and frequencies. Power Output Power: Voltage Gain: 31.55 dB gain at 1.4 volt sensitivity; 26 dB gain at 2.65 volt sensitivity. Line Voltage Requirements: Universal power supply can be configured to operate with 100,120, 200, 220, 230, 240, 250 VAC at 50 or 60 Hz. Adapters are acquired through an Authorized Service Center. Performance Frequency Response: ±0.25 dB from 20 Hz to 20 kHz. The frequency response is band limited with an 8 Hz double-integrated 3rd-order Butterworth high-pass filter and a 30 kHz 7thorder Gaussian low-pass filter. Signal to Noise (A-weighted): >100 dB below rated power. Damping Factor: >3,000 from 10 to 400 Hz. Controls Level: A calibrated rotary level control for each channel located on the front panel. Power: An on/off rocker switch located on the front panel. Input Sensitivity: A two-position switch for each channel located on the back panel near each channel’s input connectors. Bridge Output: An on/off switch located on the back panel between the input connectors which, when turned on, bridges the two output channels for twice the output voltage. “Y” Input: An on/off switch located on the back panel between the input connectors which, when turned on, parallels the two input channels. Indicators TLC: A TLC (thermal level control) LED for each channel which turns on with a dim glow shortly before the amplifier needs help dissipating heat. Clip: An orange LED for each channel which turns on when distortion of any type becomes audible in the amplifier output. IOC: A yellow LED for each channel which serves as a distortion indicator. The IOC indicators include a pulse-stretching feature that helps make them more noticeable even with rapid transient signals

İlan Özellikleri
Yenisinin Satış Fiyatı:
15000 TL
Takasa Açık:
Hayır
Pazarlığa Açık:
Hayır
Kutusu Var:
Hayır
Kullanma Klavuzu:
Yok
Durum:
3/5
Ayıplar:
Ürün 1999 çıkışlı, çalışır durumda.
Ödeme Seçenekleri:
Banka Havalesi İle Peşin